#5000k vs 6500k hid in halogen projector install#
#5000k vs 6500k hid in halogen projector update#
#5000k vs 6500k hid in halogen projector upgrade#
#5000k vs 6500k hid in halogen projector license#

This likely is the reason glare is kept to a minimum compared to the HID bulbs. No crest at the top of the beam (parallel/inline to the projector) due to diodes only being on left and right of the LED bulb.Better distance than Halogen, but not as good as HID.Barely noticed the beam pattern compared to no headlights on in the parking garage.

#5000k vs 6500k hid in halogen projector license#

In actuality, my headlights are adjusted so that my cutoff is just at the top of the license plates on the cars. That dark spot is the crest of the 'hill', and this results in the cutoff appearing to be higher than it should be on the far wall. If you look at the middle of the parking lot you'll see a black line going across left to right. It slopes up about 50 yards and then begins to slope back down. Note that in this shot the ground is not even. I went out and found the darkest garage I could find to get dry photos of the beam pattern, cutoff, spread, and any scatter. White Balance 3800K for wall shot, and 3800K for distance shot.Well, dry photos happened when I located a nice, empty parking garage.ĩPM, 38F, Parking Garage with scattered overhead lights Will color shift to approximately 4700K.Definitely brighter than Halogen, and slightly brighter than LED.Must warm up to reach peak light output.Operating temperate at the arc was 300-400 degrees F.

#5000k vs 6500k hid in halogen projector install#

More stuff to install means more places you need to mount your hardware.

Instant on with peak light output (really cool, and really nice).

Operate at about 100 degrees F +/- 20 degrees at the base AND diode regions.

#5000k vs 6500k hid in halogen projector upgrade#

The fewer parts to this upgrade make it nice.

Super easy to tuck away and cleanly install.

Operate at about 300 degrees F +/- 60 degrees.

Still, the LED bulb in dry conditions actually throws very even light that is whiter and brighter than the halogens (been running them for a month now). Here you can see how similar the beam pattern is at close range between the bulbs, save for the one that looks like a butterfly (H11 LED). Hotspots cannot be fully assessed due to the rain and wet ground, so I would like to take more photos on a dry night to further compare. Wth first hand experience from this shoot I can tell you that the glare was 'perceived' the same from my eyes and my neighbors between all the bulbs. Getting a good head-on photo to depict any glare was fruitless, since the dynamic range of a camera doesn't make for an accurate assessment with how intense all the bulbs appear to the camera sensor. The 'glare streak' on the right garage door is due to the puddle on the right side of the alley, and it exists in all photos (albeit not so prominent with the Halogen). Either way, the consistent camera settings make for as best a comparison as possible. This was to ensure we'd get a proper color comparison between each light source, and it created a photo as close to what I saw in real life. White balance was established using a gray card in ambient light. (1) Garage (shots of driver's side only, as beam is mirrored exactly left or right) No H9 bulb, because I didn't want to pay $30 bucks for bulbs that I have to modify and know I will never use.Ĭonditions of this shoot and camera settings:

XenonDepot HID Philips 5000K Xtreme kit.

XenonDepot HID Philips 4300K Xtreme kit.

#5000k vs 6500k hid in halogen projector update#

Again, I purchased these bulbs on my own accord (however they hooked me up when I told them I was from TN and going to put up legit comparison photos.) I will update this thread as I get more photos. All aftermarket HID and LED setups were purchased from XenonDepot. However, you should be able to discern the differences between the halogen, HID, and LED bulbs from the early photos. This is a work in progress in terms of getting comparison shots.